ok, the painless harness for the win. as i started i was hesitant to reorganize or cut things, but after getting into it, that just works. as soon as i have a wiring issue with my 93 it's just getting all-new from scratch too.
i really keep feeling like i want to make a funnel scoop cut into the front/side of the hood to bath the air filter. not sticking up or out at all, just thru the bulge right above/around the filter.
then here's how i ran the wiring. with no inner fenders at the moment, it's just attached to the under side of the fender at that lip. i made 2 nice big pass-thru grommets to then get behind the grill to hide the crossover and the fan relay. horn ordered, that's the green wire. i really like how all that hid really nicely behind the header latch panel. big blue wire is a ground strap. made a few different harness sections under the hood, i was worried that would look a mess but i think worked. the coil around the breather bottle are gauge sensor wires. i even put little 10-32 nutcerts in the cowl for that main harness fuse.
inside had such a massive pile of wires, but they are pre-bundled. by that time i was on a roll and just started hacking. left enough for easy servicing, wound up stuff for future use n BAM. lights work, switch is fully functional. key works, starts the damn thing, and splitting the ACC and IGN sets so the fans are on with the IGN but only the air compressors are on for the ACC.
i did end up hooking up the blinkers in the mid-bar in the headlights. hoping once i get the rear plugged in she'll actually flash.