Jeepin.com Forums - View Single Post

6DoF · 04-12-2021, 07:54 AM

so before i swung that massive chunk of cast iron out of the frame, i had measured about where i wanted to cut the tunnel on the dog house back plate. nothing like trusting in your notes and making holes! the back plate has a 6.5deg bend (same angle as engine tip) in it as well, trying to pull the face fwd and give my boot a little more room. i need to test fit with all the pedals and seat in place, but i could actually do like a 1" chamfer up that whole corner if needed too. i'll finish the rest of the tunnel first.

should have enough room on the exhaust side for an aftermarket manifold and full blanket to keep the cab cooler.

04-12-2021, 07:54 AM	#173
6DoF AKA: jeepnski Join Date: Sep 2002 Location: Pittsburgh, PA Posts: 16,539	so before i swung that massive chunk of cast iron out of the frame, i had measured about where i wanted to cut the tunnel on the dog house back plate. nothing like trusting in your notes and making holes! the back plate has a 6.5deg bend (same angle as engine tip) in it as well, trying to pull the face fwd and give my boot a little more room. i need to test fit with all the pedals and seat in place, but i could actually do like a 1" chamfer up that whole corner if needed too. i'll finish the rest of the tunnel first. should have enough room on the exhaust side for an aftermarket manifold and full blanket to keep the cab cooler.