first look at full concept! fenders mounted back n slightly down on the bedside, bedside mounted high and outboard. at full drop i have a very tight 1 finger between the tire and the fender. So unlike factory i actually lined up the body line between the cab to rear fender.
the running board is just sitting on the ground, i'll have to bend up some filler panels to get them mounted. also some kind of support cuz someone will stand on them. i'm debating how i deal with the gap to the cab after the fender moved back. buy a new re-pop board and just splice a section in? cut up 2 new boards to make one new long one? the passenger side is easy cuz it's space for the exhaust, so maybe i mount something else at the back of the cab? my only thoughts have been a Jerry Can holder for spare fuel or WMO. ... NOS bottle?
grabbed some scrap CORTEN steel i still have left over from from building the house to make the new wider header for the bed. i freaking love weathering steel, specially for a project like this. the bent sections worked out really well and is actually really stiff. it's not attached to the frame yet for access reasons ... but i'll eventually get that bolted.
5'2" wide, 9' long, 13" deep, and a flat floor. that's actually a considerable amount of space, especially for a slammed truck. i helped my wife cut all the plywood bed floor sections, used 3/4" pressure treated. once it's had some time to dry, she wants to paint or stain something interesting in it. i'm hoping to just find a 5x9 rubber mat to lay down in there.
