[6DoF]

so after a little more trim/eyeball/trim/eyeball/over-trim ... the filler plate went in. you can also see where i extended the floor cut towards the tunnel for more bad metal along the entire factory seam. then more prep involving dry time, so i filled the holes in the rear floor, that officially go crossed off the list! and back to toiling away getting the mount structure to actually line up with the mount location. notice the slot, it was way off.

the entire cab is assembled with overlap fits and i personally think they are stronger and line up the panels better, so i went with that. it's also worked really well for floor pans in a few jeeps before. and success! holds it's own weight, rocker is level with the ground still, and i won't be flintstoneing it any time soon!