'55 Chevy 3800 Cummins

6DoF · 04-30-2024, 06:53 AM

last night was busy ... got the rear bed side supports in and they worked amazing. that bed is SOLID now. i'm actually getting excited for the body work to build a tailgate. i'm torn between stitching 2 re-pop together or building one from scratch that'll open level with the bed floor. i'm leaning that direction currently.

got he tail lights installed, but not wired yet. they weren't fitting well down low with the fender crammed against the bed side upright ... then i found the exact spacing and and angled holes again up top, with a hole to run wires from already there. they just bolted on, kinda felt like a sign. up higher on the dropped truck will also be easier for the other idiot drivers to see.

chopped up the 2 battery tray's i had to make one bigger jobbie that will fit my new Group31 commercial battery. same battery as my 1st gen 12v truck, i do like to standardize. pretty sure it will actually fit on the outside of the frame behind the passenger tires with easy access by just popping off the little bed floor square back there. thinking about how to make that section quick disconnect too.

04-30-2024, 06:53 AM	#15
6DoF AKA: jeepnski Join Date: Sep 2002 Location: Pittsburgh, PA Posts: 16,552	last night was busy ... got the rear bed side supports in and they worked amazing. that bed is SOLID now. i'm actually getting excited for the body work to build a tailgate. i'm torn between stitching 2 re-pop together or building one from scratch that'll open level with the bed floor. i'm leaning that direction currently. got he tail lights installed, but not wired yet. they weren't fitting well down low with the fender crammed against the bed side upright ... then i found the exact spacing and and angled holes again up top, with a hole to run wires from already there. they just bolted on, kinda felt like a sign. up higher on the dropped truck will also be easier for the other idiot drivers to see. chopped up the 2 battery tray's i had to make one bigger jobbie that will fit my new Group31 commercial battery. same battery as my 1st gen 12v truck, i do like to standardize. pretty sure it will actually fit on the outside of the frame behind the passenger tires with easy access by just popping off the little bed floor square back there. thinking about how to make that section quick disconnect too. __________________ ...................................___ .................. ________\|\|___\____ ..;.;;.:;:;.,;..;\|/_(O)\______ /_(O)\|